TROUBLESHOOTING
Line will not advance when
you restart the machine.
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
1. Lubricate with a silicone spray.
2. Install more line (Refer to “Replacing the Cutting
Line” earlier in this manual).
3. Pull lines while alternately pressing down on and
releasing bump button.
4. Remove line from spool and rewind (Refer
to “Replacing the Cutting Line” earlier in this
manual).
Cutting head is hard to turn. Grass wrapped or built up
around head.
Clean affected parts of the machine.
Grass wraps around the out
put shaft and the trimmer head
assembly.
Cutting tall grass at ground
level.
Cut tall grass from the top down.
Liner trimmer stops and will
not start again.
1) Unit failed
2) Plug is damaged.
1) Contact dealer to check damage
2) Check the plug
DISPOSAL
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmental safe
recycling.
To Next Page
Loading...
Need help?
General
