What to do if my Ryobi Saw does not start?
If your Ryobi Saw doesn't start, make sure the motor cord or wall cord is properly plugged in. Check the circuit fuse and replace it if blown. Also, verify if the circuit breaker has tripped and reset it if necessary. If the cord or switch is damaged, it should be replaced at an authorized service center.
Why does my Ryobi RTS21 blade make poor cuts?
If your Ryobi Saw is producing poor cuts, the blade may be dull or dirty; try cleaning, sharpening, or replacing it. Ensure you're using the correct blade type for the cut you're making and that the blade is mounted correctly.
Why is the height/bevel adjusting hand-wheel hard to turn on my Ryobi Saw?
If the height/bevel adjusting handwheel on your Ryobi Saw is hard to turn, the gears or screw post inside the cabinet may be clogged with sawdust. Clean the gears or screw post to resolve this issue.
Why does my Ryobi RTS21 have excess vibration?
Excessive vibration in your Ryobi Saw can be due to several reasons. The blade might be out of balance, damaged, or warped, in which case you should replace it. Ensure the saw is securely mounted by tightening all hardware, and that the work surface is flat. Also, check the saw blade installation.
What to do if Ryobi Saw cutting binds or burns work?
If your Ryobi Saw's cutting binds or burns the work, the blade may be dull, so replace or sharpen it. Ensure the rip fence is aligned and slow the feed rate. If the wood is warped, replace it.
How to fix a Ryobi RTS21 rip fence that does not move smoothly?
If the rip fence on your Ryobi Saw does not move smoothly, it may not be mounted correctly; remount the rip fence. The rails might also be dirty or sticky, so clean and wax them. In addition, the clamp screw could be out of adjustment, so adjust the clamp screw counterclockwise.
Why wood edges away from rip fence when ripping with Ryobi RTS21?
If wood edges away from the rip fence when ripping with your Ryobi Saw, the blade may not be properly sharpened or set. Resharpen or set the blade to correct this issue.
Why does my Ryobi Saw motor labors in rip cut?
If your Ryobi Saw's motor labors during a rip cut, the blade might not be suitable for rip cuts. Change the blade to one designed for ripping, which typically has fewer teeth.
What to do if Ryobi RTS21 rip fence does not lock at rear?
If the rip fence on your Ryobi Saw does not lock at the rear, the clamp screw may be out of adjustment. Adjust the clamp screw clockwise to resolve this.
Why blade does not lower when turning height/bevel adjusting handwheel on Ryobi RTS21?
If the blade does not lower when turning the height/bevel adjusting handwheel on your Ryobi Saw, the locking lever may not be at the full left position. Move the locking lever to the left.
General| Type | Table Saw |
|---|---|
| Motor Power | 15 Amp |
| Max RPM | 5000 RPM |
| Bevel Capacity | 45 degrees |
| Arbor Size | 5/8 inches |
To Next Page
