Ryobi RY31SC01 User Manual

15 in. Surface Cleaner Attachment
RY31SC01
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator’s manual for their pressure washer
before using this accessory. To reduce the risk of injury
or property damage, spray the pressure stream in a safe
direction to ensure proper connection of all accessories
before starting any cleaning project. Fits most pressure
washers. Ensure compatibility and proper fit before us-
ing this accessory. Wear eye protection with side shields
marked to comply with ANSI Z87.1. Risk of fluid injec-
tions; do not point at people, pets, electrical devices
or the unit itself. Turn off the pressure washer before
changing or adjusting accessories. For cold water use
only. Save these instructions. Refer to them frequently
and use them to instruct other users. If you loan someone
this tool, loan them these instructions also.
PRODUCT SPECIFICATIONS
Connections .............................1/4 in. Quick Connect Plug
Deck Width ................................................................. 15 in.
Maximum Pressure ................................................ 3300 psi
Maximum Water Flow ................................................3 gpm
Maximum Water Temperature ....................................140°F
INSTALLING THE SURFACE CLEANER ON
THE SPRAY WAND
See Figure 1.
n Insert the surface cleaner inlet plug into the spray wand
quick connect coupler and secure.
WARNING:
To reduce the risk of injection or injury, only use the sur-
face cleaner on flat, horizontal surfaces. Never lift the
surface cleaner from the cleaning surface while operating
the pressure washer.
USING THE SURFACE CLEANER
See Figure 2.
n Start the pressure washer as described in your pressure
washer manual.
n Walk slowly behind the cleaning deck, cleaning as you
go.
NOTE: If striping or swirling occurs, slow your pace. If
striping or swirling continues, the surface cleaner nozzle(s)
may be clogged. See Nozzle Maintenance for how to
clean the nozzles.
Fig. 1
INLET
PLUG
Fig. 2
QUICK CONNECT
COUPLER
WARNING:
Striking any raised obstacle while using the surface
cleaner will damage the unit. If contact does occur and
causes vibration when operating the pressure washer,
stop and discontinue use. Continuing to operate the unit
could result in serious injury or damage to the unit.

Ryobi RY31SC01 Specifications

General

Brand	Ryobi
Model	RY31SC01
Category	Ultrasonic Jewelry Cleaner
Language	English

Summary

General Safety Warnings

Product Specifications

Installing the Surface Cleaner

Connecting to Spray Wand

Insert the surface cleaner inlet plug into the spray wand quick connect coupler and secure.

Using the Surface Cleaner

Operational Safety and Usage

Use only on flat surfaces. Avoid obstacles to prevent damage and vibration. Never lift while operating.

Cleaning Procedure and Troubleshooting

Start washer, walk slowly. Slow pace if striping; check for clogged nozzles.

Nozzle Maintenance

Cleaning Clogged Nozzles

Flush debris from nozzles using the cleaning tool or a needle and garden hose.

High Pressure Filter Maintenance

Replacing the High Pressure Filter

Unscrew the filter counterclockwise using a flat head screwdriver and replace it.

Replacement Parts