5
Charger LED indicator
LED Charging status
Ammeter
(Amber)
Flashing: Charger internal
temperature is high. Charging output
is reduced.
Solid: Displays the power level of
charging output. The power level
decreases as the batteries are
charged to 100%.
80% charge
(Amber)
Flashing: Batteries are disconnected.
Check battery and charger
connections.
Solid: Batteries are 80% charged.
100% charge
(Green)
Flashing: Batteries are about 90%
charged.
Solid: Batteries are 100% charged.
Charger is in maintenance mode,
monitoring and keeping the battery at
100% charged.
AC on
(Amber)
Flashing: Low AC voltage. Check
the voltage source if it matches the
charger power rating. Make sure
that the extension cord length is less
than 30 m and that the cord is rated
for 6 A.
Solid: AC power is good.
Fault
(red)
Flashing: Charger error. Reset the
charger power, and refer to the
“Charger error codes” section.
TOWING SAFETY WARNINGS
■ Use common sense when towing. Too heavy of a load
while on a slope is dangerous. Tires can lose traction
with the ground and cause you to lose control of the
product.
■ Total towed weight must not exceed the maximum
towing load of 226.8 kg (500 lbs.).
■ Attach tow equipment only at the hitch plate.
■ Never allow anyone to ride on the towed equipment.
■ Stopping distance increases with speed and weight of
load being towed. Travel slowly and allow extra time
and distance to stop.
■ Do not turn sharply when towing. Use additional caution
when turning or operating under adverse surface
conditions. Use care when reversing.
ADDITIONAL BATTERY SAFETY WARNINGS
WARNING
To reduce the risk of fi re, personal injury, and product
damage due to short circuit, never immerse your tool,
battery pack, or charger in fl uid or allow a fl uid to fl ow
inside them. Corrosive or conductive fl uids, such as
seawater, certain industrial chemicals, and bleach or
bleach-containing products, etc., can cause a short
circuit.
WARNING
Risk of fi re, explosion, or burns. Do not disassemble,
expose to heat above 60˚C, or incinerate the battery
pack.
■ The battery pack contains acid. If acid comes in contact
with skin or clothing, fl ush immediately with water for
10 minutes. If liquid comes in contact with eyes, seek
medical help immediately.
■ Do not charge battery packs that show signs of leaks.
Dispose of them properly.
■ Do not charge the battery pack at temperatures above
49˚C (120˚F).
BATTERY PACK REMOVAL AND PREPARATION FOR
RECYCLING
To preserve natural resources, recycle or dispose of
batteries properly.
The product contains lead-acid batteries. Local regulations
may prohibit disposal of lead-acid batteries in ordinary
trash. Consult your local waste authority for information
regarding available recycling and/or disposal options.
WARNING
Upon removal, cover the battery pack terminals with
heavy-duty adhesive tape. Do not attempt to destroy
or disassemble battery pack or remove any of its
components. Lead-acid batteries must be recycled or
disposed of properly. Never touch both terminals with
metal objects and body parts as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fi re and/or serious injury.
FEATURES
KNOW YOUR PRODUCT
See page 13.
For safety, read and understand the information on the
product and in this manual. Familiarise all operating
features and safety rules before using the product.
BATTERY LEVEL INDICATOR / HOUR METER
The battery level indicator shows the amount of battery
charge remaining. The hour–meter tracks the total number
of hours the product has been used (key in on position) for
maintenance purposes.
To Next Page
