13 — English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handle not in position. Handle locks not locked. Lock upper and lower handle locks.
Snow blower not starting. Snow blower is unplugged.
Start button is not depressed.
Connect snow blower to power supply.
Press start button.
The motor is on but the impeller does
not turn.
The drive belt is worn or broken. Have the drive belt replaced by an au-
thorized service center.
After passing, the snow blower leaves
a layer of snow on the ground.
The impeller/scraper mechanism is
worn.
Have the impeller/scraper mechanism
replaced by an authorized service
center.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the Ryobi
Help Line!
To Next Page
Loading...
Need help?
General
