To Next PageTo Next Page
Need help?Do you have a question about the Ryobi Tek4 HP54L and is the answer not in the manual?
General| Voltage | 4V |
|---|---|
| Battery Type | Lithium-Ion |
| Chuck Size | 1/4 inch |
| Torque | 44 in-lbs |
| Speed | 200 RPM |
| Chuck Type | Hex |
Keep work area clean, well-lit, and free from flammable materials. Avoid explosive atmospheres and distractions.
Ensure proper plug match, avoid grounded surfaces, rain, or wet conditions. Use GFCI for damp locations.
Stay alert, use PPE (eye protection), prevent accidental starting, dress properly, maintain footing and balance.
Use correct tool, don't force, maintain tools, keep cutting tools sharp, use as instructed.
Hold tool by insulated grips, know your tool, wear eye protection, protect lungs and hearing.
Be aware of hazards, do not crush/drop batteries, avoid ignition sources, do not charge in wet locations.
Explanation of DANGER, WARNING, CAUTION, and NOTICE signal words used in the manual.
Explanation of symbols like Safety Alert, Read Manual, Eye Protection, Wet Conditions, and Recycle.
Details No Load Speed, Torque, and Collet size for the screwdriver.
Do not use if incomplete or damaged. Do not modify product or create unrecommended accessories.
Instructions for securely installing and removing the battery pack, including the cap.
Controls forward, reverse, and center lock for bit rotation. Stop collet before changing direction.
Selects low speed (more power) for screws or high speed (more power) for drilling.
Insert bit into collet as far as possible. Use 2-inch bits for easier removal.
Sets torque for driving screws into different materials and screw sizes.
Illuminates work area when the switch trigger is depressed.
Use identical replacement parts. Avoid solvents on plastic parts; use clean cloths for dirt, dust, oil, grease.
