9. ACCESS
CONTROL
9. ACCESS CONTROL
Access control (i.e. carcalls lock) feature is now available. This means that if a car call is locked, a correspond-
ing passcode must be entered to register and service this car call.
9.1 LOCKED FLOORS PASSCODES AND LOCKED FLOORS
9.1 LOCKED FLOORS PASSCODES AND LOCKED FLOORS
In the menu, go to the "Access Control" page. There are two options to select: Disabled/Enabled.
When set to Disabled, no carcall is locked. Therefore, carcalls can be registered freely.
When set to Enabled, it is possible to choose the locked oors and their corresponding passcodes.
“Cabin Lock1 FL#”, “Cabin Lock2 FL#”, “Cabin Lock3 FL#” …. “Cabin Lock8 FL#” pages are used to select the
locked oors and their related passcodes. These passcodes consist of 4 digits.
Once "Access control" is Enabled, “Cabin Lock1 FL#” page will become accessible. The default option is ALL,
meaning that all oors will be locked and their passcode is set to 0000.
Locked oors can be:
1- "ALL" to lock all oors. No carcalls (CCs) will be served unless the correct passcode is entered.
2- Floors from "0" to "last oor" to lock only up to 8 specied oors.
3- "-" to end selecting locked oors. Note that “-“cannot be chosen for the “Cabin Lock1 FL#”.
To modify these settings, push the rightmost push button. ALL will start to blink. To lock a specic oor, use
the leftmost push button to decrement the digit and the middle push button to increment the digit. When
the desired oor to be locked is reached, push the right most push button.
Once the locked oor is selected, the rst digit of the passcode on the left starts blinking. Use the leftmost
push button to decrement the digit and the middle push button to increment the digit. When the desired
digit is reached, push the right most push button. The next digit starts blinking. Repeat the above procedure
for the remaining 3 digits. Take care to select passcode digits that are only present in the COP (Car Operating
Panel). Lowest oor is considered as Zero, the next oor is 1 …
9.2 ACCESSING THE CARCALLS
9.2 ACCESSING THE CARCALLS
Unlocked Carcalls will be registered and served normally. Locked Carcalls will be registered only after their
corresponding passcode is entered.
When a locked carcall is pressed, it will start to blink informing the user that it is locked. The passcode must
be entered within 5 seconds to register it.
For example, if the locked carcall is “5” and its corresponding passcode is “2658”.
To register this car call, you have to press 5, 2, 6, 5 and 8 within 5 seconds. The carcall button will light after
the last digit of the passcode is pressed.
To Next Page
Loading...