S-Lighting S-3 - Mounting and Rigging Instructions; LED Lifespan and Longevity

S-LIGHTING S-3 www.slservice.pl 6
Mounting & rigging
This device can be mounted in any orientation (vertical, horizontal).
Always make sure there is adequate ventilation and no ammable
surfaces within 2 feet (0.6 meters) of the device. You can mount
the device using clamps or with threaded bolt type hardware.
Always install the included safety eyebolt and cable when mounting
in overhead or wall locations.
Expected LED lifespan
LEDs gradually decline in brightness over time, mostly because
of heat. Packaged in clusters, LEDs exhibit higher operating
temperatures than in ideal, single LED conditions. For this
reason, using clustered LEDs at their fullest intensity signicantly
reduces the LEDs’ lifespan. Under normal conditions, this lifespan
can be 40’000 to 50’000 hours.
If extending this lifespan is vital, lower the operating temperatu-
re by improving the ventilation around the product and reducing
the ambient temperature to an optimal operating range. In addition,
limiting the overall projection intensity may also help to extend
the LEDs’ lifespan.
Warning: Do not mount the xture in the
ventilation path of a nearby heating supply
duct. The heated airow will cause device
failure due to overheating.