14
ON-DECK MOUNTING INSTRUCTIONS
1. Place the assembled slide on the deck relative to the pool wall. Ensure that the exit flume clears
any coping. Slide may be angled slightly providing all dimensions are maintained as noted in the
Manufacturer’s Placement Instructions noted in the following section.
2. With the slide in its proper location, center punch or otherwise mark
through the (8) mounting holes at the bottom of the ladder and
pedestal so that a visible mark is apparent on the concrete.
3. Move the assembled slide aside to facilitate drilling of the anchoring
holes.
4. Using a power drill and a 1/2” (13 mm) concrete drill bit,
drill the holes to a depth of 4” (102 mm). Use tape or a
marking on the drill bit to ensure that the hole for the
anchor is drilled to the required depth. Maintain drill hole
straight and perpendicular for proper holding strength of
anchor stud
5. Clear the holes of all debris. Assemble anchor with nut and washer so
that the top of the nut is flush with the top of the anchor. Move the
slide over the holes before inserting the anchors. Drive anchor
through the slide mounting holes so that nut and washer are flush
with the surface material.
6. Ensure the slide ladder is plumb by placing a level on a ladder tread.
If necessary, shims can be placed beneath the base of the ladder to
ensure it is plumb due to varying deck slopes.
7. Expand anchor by tightening nut 3 to 5 turns. Once anchor is set
remove nut and install a lock washer, item # (3), and retighten nut to a
torque of 25 ft.-lbs (33.9 N-m).
To Next Page
Loading...
