229Car care
License plate lighting
1 Undo the two screws and remove the
lens.
2 Fit the new bulb.
3 Make sure the seal on the lens is
correctly seated.
4 Refit the lens and tighten the two
screws.
Glove box lighting 3
1 Remove the lamp housing using a short
screwdriver.
2 Fit the new bulb.
3 Insert the connector side first when refit-
ting the lamp.
Hatch opened for replacement of center
bulb
Reverse side of the light fitting. The
arrows mark the outer bulbs
93_US_7carcare_MY09.fm Page 229 Tuesday, April 15, 2008 11:26 AM
To Next Page
Loading...
