255Car care
Malfunctions
The above message is shown on the SID if:
• Wheel without pressure sensor has been
fitted (e.g. spare wheel)
• One or more pressure sensors are broken
or missing
• A fault has arisen in the receiver
• A system error has arisen.
Removing a tire
Remove the tire with a tire machine. It is
important to follow the instructions for the
tire machine as well.
•Do not fit the tire tool in an area ±10° from
the valve
• Start removing opposite the valve
• Remove the rear side first.
Fitting a tire
Fit the tire with a tire machine. It is important
to follow the instructions for the tire machine
as well.
• Start to fit about 20° after the valve
• Finish fitting before an area 20° from the
valve
•Do not inflate the tire to a pressure higher
than 102 psi (700 kPa).
Tire pressure system
failure. Contact service.
93_US_7carcare_MY09.fm Page 255 Tuesday, April 15, 2008 11:26 AM
To Next Page
Loading...
