Installation
Position the appliance and allow it to stand for two to three hours
before it is turned on for the rst time to allow the system to settle.
Do not position next to any heat source e.g. cooker, boiler or in direct
sunlight etc.
Allow at least 10 cm of space at the top and 10 cm of space on both
sides of the appliance and between the back of the appliance and
the wall for adequate air circulation. The appliance is not designed
for recessed installation (“building in”). Install on a good rm level
surface, and any unevenness of the oor should be corrected prior
to installation, slight unevenness can be overcome by adjusting the
front feet.
NOTE: If the appliance is positioned on a carpet, soft oor covering
you should readjust the front feet once the appliance has had time to
settle.
Use
• This appliance is designed to operate in ambient temperature
between 16°C and 43°C. If these temperatures are exceeded,
i.e. colder or warmer, the appliance will not operate correctly.
If the ambient temperatures are exceeded for long periods, the
temperature in the freezer section will rise above -18°C and food
spoilage may occur.
• Remove all packaging materials from the appliance. Wash the
inside of the cabinet with lukewarm water and bicarbonate of
soda (5ml to 0.5 liter of water). Dry the appliance thoroughly.
• When you use the freezer for the rst time or after defrosting, set
the thermostat control to the maximum position for at least 2
hours before introducing food to be stored, and then readjust to
the normal position.
• If there is a power failure, do not open the door. Frozen food
should not be aected if the failure lasts for less than 12 hours. If
the failure is longer, then the food should be checked and either
eaten immediately or cooked and then re-frozen.
2625
To Next Page
Loading...
Need help?
General
