Right Wrong
Drill holes at the marked points, using a Φ10 mm drill bit and
insert the wall plugs 11 into the holes�
For version A, x 2 screws 10 (5 x 50) into the holes on line B2,
keeping around 10mm out of the wall plug for further hooking
the hood�
Fix the brackets (version B):
Fix bracket 20 on line B1 and bracket 21 on line A with 5 screws
10 (50x50) provided with the unit�
Hook the hood unit
Open the panel and remove the metal grease lter using the
handles provided�
• Version A: hook the hood unit on screws 10 on line B2 and
terminate the screwing
• Version B: Hook the hood unit on bracket 20� Check the unit
level in both cases�
• From interior of the hood unit, x rmly the screws 10 to wall
plugs 11 at the points (3) on line C�
• Fit the lter into the hood�
• Close the panel�
32
GB
To Next Page
