The lter unit consists of a
main lter (1), central lter
(2) and micro lter (3)�
Turn the assembled central and micro lters anticlockwise to unlock
them from the appliance� Separate the lters�
Lift up the main lter�
Rinse them under running water using a soft brush�
To disassemble the lters
Cleaning the Filter Unit
Clean the lters regularly� Replace the lter unit by turning them
clockwise until they lock into position�
CAUTION: Never operate the dishwasher without the lters�
Use a damp cloth to clean the edge around the door�
To avoid penetration of water into the door lock and electrical
components, do not use a spray cleaner�
Cleaning the Door
Avoid placing the dishwasher in a location where the temperature
is below 0°C� If this is unavoidable, empty the dishwasher, close the
door, disconnect the water inlet pipe and empty it�
Frost Precautions
The spray arms can be easily removed for periodic
cleaning of the nozzles, to prevent possible
clogging�
To remove the upper and lower spray arms, hold
and unscrew or pull them out�
Wash the spray arms under running water and
attach them back in place, checking that the
rotary movement is in no way impeded.
Cleaning the Spray Arms
6160
To Next Page
Loading...
Need help?
General
