Saba TGV60N3F/C - Automatic Ignition and Flame Failure

16
GB
head in the event of the ame going out.
To ignite a burner:
• Press in the control knob of the burner that you wish to light
and turn it anti-clockwise to the maximum position.
• If you keep the control knob depressed, the automatic ignition
for the burner will operate.
• You should hold down the control knob for 15 seconds after
the ame on the burner has lit. If after 15s the burner has not
lit, stop operating the device and open the compartment door
Automatic ignition with ame failure safety device
The appliance is tted with a ame failure safety device on each
burner, which is designed to stop the ow of gas to the burner
head in the event of the ame going out.
Automatic ignition with ame failure safety device
The appliance is tted with a ame failure safety device on each
burner, which is designed to stop the ow of gas to the burner
and/or wait at least 1 min before attempting a further ignition
of the burner.
• After this 15-second interval, to regulate the ame you should
continue turning the control knob anti-clockwise until the