GB
41
2 Adjustment of minimum level of the ame.
1. Turn the taps down to minimum.
2. Remove the knob from the tap and place a small bladed
screwdriver in the centre of the tap shaft.
3. The correct adjustment is obtained when the ame has a
length of about 3 - 4 mm.
– For butane/ propane gas, the adjusting screw must be
tightly screwed in.
– Ret the control knob.
Make sure that the ame does not go out by quickly turning
from maximum ow to minimum ow. If it does then
remove the control knob and make further adjustments to
the gas ow, testing it again once the adjustment has been
made.
4. Repeat this process for each one of the gas taps.
Control handle
Tap
Sealing ring
Adjustment screw
To Next Page
Loading...