17
ENGLISH
Directing the air flow
Manually adjust the diffuser and air diffuser fins to direct the
cool air that flows from the air conditioner.
We recommend aiming the fins upward for better air diffusion.
Problem Cause Solution
The air conditioner has
completely stopped.
Power failure or unit not properly
plugged into the power socket.
Check the plug and the connection.
Call your electrician.
The cut-out switch or line fuse
has been tripped.
Call your electrician.
Line voltage too low. Call your electrician.
Air conditioner powered
but not working.
The operating mode is not set. Select an operating mode.
The air conditioner is not
cooling.
The lter is dirty. Clean the lter.
Doors or windows open. Close the doors or windows.
Selected temperature is too high. Lower the selected temperature.
The compressor does not start. The overload cut-out is tripped, wait
for the compressor to cool down.
The room is too large, has
a very high sun exposure
and/or contains numerous heat
sources.*
To correct problems that have not been described in the table and/or if the recommended solutions
fail to solve the problem, contact an authorized service centre.
* This is not a machine defect.
TROUBLE SHOOTING
DRAINAGE
The unit is equipped with an automatic drainage function.
The condensed water will be pumped from the back of
the indoor unit to the outdoor unit.
You may also connect a water tube (dia. 14.5 mm) to the
discharge hole in the outdoor unit to channel the water
away.
Make sure the water always drains away freely.
Water tube
Downloaded from www.vandenborre.be
To Next Page
Loading...