Outboard Bass Preamp / DI
SBP-1
Mute Switch
The Mute switch will mute the signal of the bass. The Mute LED lights up when in mute mode.
The Tuner Out will remain active in the mute mode.
XLR Out
The XLR output enables you to plug directly into a PA or recording console or any other device
that accepts an XLR connection. The output is accurate and quiet for recording and all
professional applications.
Ground Lift
If a hum occurs while using the XLR output, engage the ground lift switch. When the switch is
set to the right (under the word, 'Lift') the ground is lifted.
Low Battery LED
The Lo Batt LED will begin to glow when the battery reaches 7.5 volts. We recommend you
replace the 9V battery at this time. To extend battery life, unplug the cord going into the
input jack as the battery is draining anytime that jack is activated. This is not necessary on short
breaks while gigging, but do not leave the unit plugged in overnight when not being used.
AC Adapter
An input jack for an AC adapter is located on the right side of the unit. The Sadowsky Preamp
requires a linear regulated power supply for quiet operation. For very noise sensitive applications,
battery operation might provide the most quiet operation.
To Next Page
Loading...