ENGLISH
13
will start to come out of the spout (F ig.01,
pos.13).
The coffee will stop flowing automatically when
the preset level is reached (see par.7.3). Y ou
can interrupt the flow of coffee by pressing
the button (Fig.01, pos.23 or 24).
7.2 Making coffee with preground coffee
In this operating mode, you must use
the supplied measuring scoop
(Fig.01, pos.21) to dose the preground coffee.
Only use ground coffee suitable for
espresso coffee makers in the doser
(5); placing coffee beans, instant coffee and
other materials inside the doser causes
damage to the appliance.
Keep fingers away from the preground
coffee doser since there are moving
parts.
Use the supplied measuring scoop (21) to
measure the right quantity of preground coffee
to place in the doser.
Use only one level measuring scoop at a time;
to make two cups of coffee using preground,
you must go through the entire process twice.
Press the button (22) to select the preground
function, the LED lights up.
Lift the lid of the preground coffee doser
(Fig.13).
Fill one level scoop of preground coffee; discard
any excess quantity of ground coffee.
Fill the doser with the preground coffee (Fig.13)
Close the lid of the preground coffee
doser.
To make the coffee, press the desired coffee
button (23) or (24); the selected button starts
flashing (see chapter 15), while the other
switches off.
The dispensing cycle begins.
After carrying out the prebrewing cycle, coffee
will start to come out of the spout (13).
The coffee will stop flowing automatically when
the preset level is reached (see par. 7.3).
You can interrupt the flow of coffee by pressing
either coffee button (23) or (24).
Then the machine automatically returns to the
normal operating mode (see para. 7.1).
7.3 Adjusting the quantity of coffee per
cup
Your coffee maker has been programmed to
make 2 types of coffee: espresso coffee with the
button (23) and long coffee with the button (24).
To adjust the programmed values to the size of
your cups, place the cup under the coffee
dispenser (13), press the button of the desired
type of coffee (23) or (24) and keep it pressed.
Wait for the machine to fill the cup up to the
desired level and, then, release the button.
Note: keep coffee button (23) or (24)
pressed during the entire coffee
dispensing process. Maximum level is 8 oz.
In this way, the appliance is reprogrammed
to supply the quantity of coffee you selected.
8 DISPENSING HOT WATER
Caution: splashing may occur at the
start - scalding hazard! The hot water
nozzle can reach high temperatures: avoid
touching directly with your hands.
Before dispensing hot water, make sure that
the hot water button (25) is activated (light
will be on steady).
Proceed as follows when the appliance is ready
to dispense hot water:
Place a cup and/or pitcher under the steam/
hot water nozzle (Fig.15).
Turn the knob counterclockwise as shown in Fig.15.
When you have obtained the desired quantity
of hot water, turn the knob clockwise to shut
off the flow. The appliance is immediately ready
to brew coffee.
9 DISPENSING STEAM / PREPARING
CAPPUCCINO
Steam can be used to froth milk for
cappuccinos and also to heat other
beverages.
Scalding hazard!
Splashing may occur at the start -
scalding hazard! The hot water nozzle can
reach high temperatures: avoid touching
To Next Page
Loading...
