What to do if Saeco Intuita HD8750 dispenses no hot water or steam?
If your Saeco Coffee Maker is not dispensing hot water or steam, the hole of the steam wand may be clogged. Clean it using a pin, making sure the machine is off and cooled down first. Another cause might be a dirty Automatic Milk Frother; in that case, clean the Automatic Milk Frother.
How to fix Saeco Coffee Maker when coffee leaks from dispensing spout?
If coffee leaks out of the dispensing spout of your Saeco Coffee Maker, it's likely that the dispensing spout is clogged. Clean the dispensing spout and its holes to resolve this.
How to make Saeco Intuita HD8750 Coffee Maker coffee hotter?
If your coffee from the Saeco Coffee Maker is not hot enough, the cups may be cold. Try preheating them with hot water before brewing.
Why is my Saeco Intuita HD8750 Coffee Maker brewing coffee so slowly?
If your Saeco Coffee Maker is brewing coffee slowly, it could be due to several reasons. The coffee grind might be too fine, so you may need to change the coffee blend or adjust the grind as explained in the “Adjusting the Coffee Grinder” chapter. Also, the circuit may not be primed, so prime the circuit. The brew group might be dirty, so clean the brew group.
Why does Saeco Intuita HD8750 take long time to warm up?
If your Saeco Coffee Maker takes a long time to warm up or the amount of water dispensed is too little, the machine circuit may be clogged by limescale. Descale the machine to resolve this issue.
Why is my Saeco Coffee Maker grinding beans but no coffee comes out?
If your Saeco Coffee Maker grinds beans but no coffee comes out, several issues could be the cause. First, check if the water tank is empty and, if so, fill it and prime the circuit. The brew group might be dirty, so clean it. Also, the circuit may need priming. If the machine is automatically adjusting the dose, brew a few cups of coffee as described in the “Saeco Adapting System” chapter. Finally, the dispensing spout could be dirty, so ensure that it is cleaned.
What to do if brew group cannot be removed from Saeco Intuita HD8750 Coffee Maker?
If the brew group of your Saeco Coffee Maker cannot be removed, it might be out of place. Turn on the machine and close the service door so the brew group automatically returns to the initial position. Also, make sure that the coffee grounds drawer is removed before removing the brew group.
Why is the red light blinking fast on my Saeco Coffee Maker?
If a fast blinking red light is always displayed on your Saeco Coffee Maker, it means that the coffee grounds drawer was emptied with the machine on. The coffee grounds drawer must always be emptied with the machine on. Wait until the red light starts blinking more slowly before reinserting the drawer.
Why is there ground coffee under the brew group of my Saeco Coffee Maker?
If there is a lot of ground coffee under the brew group in your Saeco Coffee Maker, the coffee may not be suitable for automatic machines. It may be necessary to change the type of coffee or the coffee grinder settings.
Why is the coffee too weak from my Saeco Coffee Maker?
If the coffee from your Saeco Coffee Maker is too weak, it might be because the machine is automatically adjusting the dose. Brew a few cups of coffee as described in the “Saeco Adapting System” chapter.
General| Water Tank Capacity | 1.5 L |
|---|---|
| Pump Pressure | 15 bar |
| Removable Brewing Group | Yes |
| Adjustable Grinder Settings | Yes |
| Hot Water / Steam Nozzle | Yes |
| Pre-brewing | Yes |
| Color | Black |
| Voltage | 230 V |
| Number of Boilers | 1 |
| Coffee Bean Container Capacity | 300 grams |
To Next Page
