To Next PageTo Next Page
Need help?Do you have a question about the SAER Elettropompe FC 25-2C and is the answer not in the manual?
Appliance is not for use by children or persons with reduced capabilities without supervision or instruction.
Connect pump via omni-polar switch; ensure disconnection device meets over-voltage category III.
Install a high-sensitivity RCD (max 0.03 A) for electrical safety.
Ensure the pump is properly earthed for electrical safety.
Ensure free ventilation of the motor for proper operation and longevity.
Details on pump design, identification data, and approved applications.
Guidelines for electrical compatibility, connection standards, pipe support, and pump placement.
Instructions for priming the pump by filling it with water before starting.
A guide to identifying and resolving common pump failures.
General| Type | Centrifugal Pump |
|---|---|
| Material | Cast Iron |
| Power | 0.37 kW |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Maximum head | 32 m |
| Outlet size | 1 inch |
| Phase | Single phase |
