39
■ Bur Insertion
1. Turn the handle to open the handpiece chuck.
2. Insert the bur in the front of handpiece.
3. Lock the handpiece chuck by turning the handle.
※ Bur connection method is same regardless of the handpiece type.
- Be sure to lock the chuck before use. It may cause damage to the handpiece.
- Make sure that the bur is not damaged.
- Check the Bur dimension. (Bur Dimension: Φ2.35mm)
CONNECTION OF EACH PART
■ Control Box Connection
1. Connect the power cord to the power socket.
- Before connect the power cord, make sure to check the power off.
- Make sure to check that the speed control dial is set to ‘0’.
2. Connect the foot controller cord.
3. Connect the handpiece cord.
To Next Page
Loading...
