What to do if SAESHIN Dental equipment charging station does not work?
If the charging station for your SAESHIN dental equipment isn't working (the CHARGE lamp does not light), check the following: * Ensure the charger's plug is properly inserted into the outlet and that the outlet has electricity. If not, check the connections. * If the internal fuse has burnt, contact your dealer.
Why is the SAESHIN Dental equipment motor handpiece overheating?
If the temperature of your SAESHIN dental equipment motor handpiece is high, it could be because the battery temperature is high. It's normal for batteries to be a little warm after charging. However, if the batteries are hot during normal operation, it may indicate an issue. Contact your dealer in such cases.
What to do if SAESHIN Traus ENDO Dental equipment motor handpiece does not rotate?
If your SAESHIN dental equipment motor handpiece isn't rotating, the contra angle might be stuck. Try cleaning the head or changing it.
Specifies the product's intended use in endodontic procedures.
Provides essential safety precautions and warnings for product operation.
Important warnings regarding battery use, sterilization, and product handling.
Lists prohibited actions and conditions to avoid for safe and proper product use.
Detailed instructions for turning on, operating, and turning off the device.
Explains the cause and remedy for error code E-1.
Lists common problems and their solutions for the product.
Detailed steps for cleaning the angle handpiece, prophy head, and motor handpiece.
Instructions for sterilizing applicable parts using moist heat sterilization.
Information on the product's radiofrequency emissions and compliance.
Details the product's susceptibility to electromagnetic interference.
General| Brand | SAESHIN |
|---|---|
| Model | Traus ENDO |
| Category | Dental equipment |
| Language | English |
To Next Page
