Strong 210. Product data sheet and operating manual.
Technical specifications
Power supply: 220 V, 50 Hz.
Dimensions of the control unit: 130x135x85 mm.
Weight of the control unit: 1.3 kg.
The units can be equipped in a variety of ways:
•
with tip 107ll, without pedal with bag;
•
with 107ll tip, with pedal in the box;
•
with tip 120, with foot pedal, without bag;
•
with tip 120, with pedal and bag;
•
with 105L tip, with foot pedal without bag;
Note
Distance between the tip
and the nozzle must be at least 2 mm.
The nozzle should only be changed
when the micromotor is switched off.
Otherwise, the machine may malfunction.
Attention!
To clamp the nozzle stem
The collet clamp must be closed by turning the
upper part of the handle anti-clockwise until it
clicks into place.
Attention!
Switch off the machine (mains indicator must not be illuminated) if it is not used
for more than three hours! Otherwise the machine may overheat!
To Next Page