When the heating appliance is used for the very first time, it must first dry out completely. For this
purpose,
heat it for one hour with a small quantity of fuel. Set the air inlet to
“ I “.
During this phase, a slight odour may be given off due to the curing of the primer used.
Keep an eye on the appliance during this phase and immediately remove any water formed by
condensation, before it can burn into the enamel or the lacquer.
10. The controls
Adjustment of the feet
In order to make levelling of the appliance possible, the feet on both sides have small setscrews that
can be
adjusted separately.
50
Opening the door
To Next Page
Loading...
