SAF TIGMATE 400 AC/DC User Manual

TIGMATE 270 AC/DCTIGMATE 270 AC/DC
TIGMATE 400 AC/DCTIGMATE 400 AC/DC
INSTRUCTION DE SECURITE D'EMPLOI ET INSTRUCTION DE SECURITE D'EMPLOI ET
D'ENTRETIEND'ENTRETIEN
SAFETY INSTRUCTIONS FOR USE AND MAINTENANCESAFETY INSTRUCTIONS FOR USE AND MAINTENANCE
BETRIEBS- UND BETRIEBS- UND
WARTUNGS-SICHWARTUNGS-SICH
ERHEITSANLEITERHEITSANLEIT
UNGUNG
ISTRUZIONI DI SICUREZZA, D’UTILIZZO E ISTRUZIONI DI SICUREZZA, D’UTILIZZO E
DI MANUTENZIONEDI MANUTENZIONE
INSTRUCCIONINSTRUCCION
ES DE ES DE
SEGURIDAD, EMPLEO Y SEGURIDAD, EMPLEO Y
MANTENIMIENTOMANTENIMIENTO
INSTRUÇÕES DE SEGURANÇA E DE MANUTENÇÃOINSTRUÇÕES DE SEGURANÇA E DE MANUTENÇÃO
VEILIGHEIDSINVEILIGHEIDSIN
STRUCTIES VOOR STRUCTIES VOOR
GEBRUIK EN GEBRUIK EN
ONDERHOUDONDERHOUD
INSTRUKTIONEINSTRUKTIONE
R FÖR R FÖR
SÄKERHET, ANVÄNDNING OCH SÄKERHET, ANVÄNDNING OCH
UNDERHÅLLUNDERHÅLL
EDITION EDITION
: :
F F
/ /
GB GB
/ /
D D
/ /
I I
/ /
E E
/ /
P P
/ /
NL NL
/ S/ S
RERE
FF
8686
9595
-0-0
8686
00
RR
EE
VV
II
SS
II
OO
NN
: :
00
22
DD
SS
22
33
11
--
22
77
88
DD
AA
TT
EE
: :
00
44
--
22
00
00
00

SAF TIGMATE 400 AC/DC Specifications

General

Brand	SAF
Model	TIGMATE 400 AC/DC
Category	Portable Generator
Language	English

Summary

SAFETY INSTRUCTIONS

General Safety Precautions

Lists essential safety topics to read before operating the welding set.

Electric Safety (Connection, Maintenance, Troubleshooting)

Detailed safety measures for electrical connections, maintenance, and troubleshooting.

Connecting Welding Current Sources to Mains

Procedures for safely connecting the generator to the power supply.

STARTING UP

Unpacking the Installation

Instructions for safely removing the welding unit from its packaging.

Electrical Connections to the Mains

Procedures for connecting the generator to the power supply.

Gas Inlet Connection (ON PRESSURE REGULATOR)

How to connect the gas supply to the generator via the regulator.

Equipment Connection

Steps for connecting the welding torch and ground clamp.

INSTRUCTIONS FOR USE

Commissioning

Initial steps to put the generator into operation.

Selection of Welding Mode

How to choose between covered electrode, 2-stroke, 4-stroke, or stapling modes.

Selection of Welding Current

How to choose between alternating and direct welding current.

Selection of Balance

ADJUSTMENT OF WELDING PARAMETERS

Pre-Gas Adjustment

Welding Current Gradient Adjustment

Welding Current Adjustment

Fading Adjustment

Post-Gas Adjustment

SELECTION OF WELDING CYCLES

2-Action Cycle

4-Action Cycle

Stapling Cycle

E - MAINTENANCE

Cleaning and General Care

DIAGNOSIS CHART

Troubleshooting Guide

A table listing common causes and remedies for welding issues.