Connect a PS/2-to-USB adapter cable between the card reader and a USB port on
your computer.
If you prefer to not expose USB ports on your crypto server (for security reasons),
then connect a PS/2-to-USB adapter cable between the card reader and a
standalone powered USB hub.
Again, the USB connection is for power only. No data transfer occurs.
Completing Installation
Following the PCI HSM Access Provider installation, to make use of the
ProtectServer, you will need to install the supplied SafeNet API or net server
software.
Please refer to the installation instructions in the appropriate manual, such as the
ProtectToolkit C Installation Guide.
To Next Page
Loading...