Examine Your Warmer
Unpack warmer, remove all packing material and examine the unit for any damage such as dents, broken door hinges or cracks in the door. Notify
Sage Products immediately if warmer is damaged. DO NOT install or operate if warmer is damaged.
Remove Protective Plastic Film
If a plastic film has been wrapped around the warmer to protect the painted finish from scratching during shipping, please remove this plastic film
prior to use. (However, not all warmers have plastic film wrapping.)
Placement of Warmer
1. Warmer must be placed on a flat, stable surface. For proper operation, the warmer must have sufficient air flow. Allow 3 inches (7.62cm) of
space on both sides of the warmer and 1 inch (2.54cm) of space on top of the warmer.
a) DO NOT block air vent. If it is blocked during operation, the warmer may overheat. If overheating occurs, a thermal safety device
will turn the unit off. The warmer will remain inoperable until it has cooled.
b) DO NOT place warmer near a hot, damp surface, such as a gas or electric range.
c) Be certain that power cord on the warmer can reach the electrical outlet.
d) Be certain electrical outlet is not blocked by the warmer. Power cord must be able to be unplugged without moving the warmer.
2. Warmer should be located in or near the nurse’s station or supply room.
Grounding Instructions
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of an electric shock by providing an escape
wire for the electric current. This appliance is equipped with a cord having a grounded wire with a grounded plug. The plug must be plugged into an
outlet that is properly installed and grounded.
WARNING: Improper use of the grounding plug can result in a risk of electric shock.
Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if doubt exists as to whether the
appliance is properly grounded.
If it is necessary to use an extension cord, use only a three slot receptacle that will accept the plug on the appliance. The marked rating of the
extension cord should be equal to or greater than the electrical rating of the appliance.
Wiring Requirements
1. For US customers, the warmer must be plugged into at least a 15 AMP 110 VOLT, 60 Hz GROUNDED OUTLET.
The warmer is designed to accept either:
a) US: AC Input Voltage of 110 V AC (± 20%), AC Input Frequency of 60 Hz (± 3 Hz)
b) EU: AC Input Voltage of 230 V AC (± 10%), AC Input Frequency of 50 Hz (± 3 Hz).
2. The power cord shipped with the warmer will be region specific.
3. For US customers where a standard two-prong outlet is encountered,
it is the personal responsibility and obligation of the user to have it replaced
with a properly grounded three-prong outlet (Figure 1).
4. The warmer must be on a SEPARATE CIRCUIT. No other appliance should share the circuit with the warmer. If it does, the branch circuit fuse
may blow, the circuit breaker may trip or products may warm slower than expected.
5. The VOLTAGE used must be the same as specified on the warmer (110 V or 230 V). Using a higher voltage may result in a fire or other accident
causing warmer damage. Using a lower voltage will cause slow heating. Sage Products Inc. is NOT responsible for damage resulting from the use
of the warmer with other than specified voltage.
INSTALLATION AND GROUNDING INSTRUCTIONS
Figure 1
To Next Page
Loading...