Technical Site Documentation myC5-2
Ref. SCT U38 SSC DTS 0024 – Index B - February 15, 2005 Page 4-30
CHAPTER 4 - TESTS AND CHECKS
4.1 ABOUT TESTS
Tests and checks are made after the troubleshooting procedures (chapter 3) and before the maintenance
procedures (chapter 5).
They are broken down into modules and are sorted by types of confirmed faults. The user must be
equipped with special test tools in order to carry out the tests.
4.2 TEST TOOLS
The references of SAGEM tools, listed hereafter, are given in Appendix 1 : Composition table.
The following test tools are necessary :
1. the ARC downloading kit, including the test case provided with:
• the data cable (to PC),
• the retrofit cable,
• the mains power supply module.
• Retrofit adapter
2. the radio test bench, provided with:
• SIM card of test.
• MyC5-2 calibration tool
• Adjustable regulate power supply 0-15V / 4A
• Wavetek 4107
− CADEX C7000 / C7200 / ASTRATEK with myC5-2 adapter
• Charger test kit
• Voltmeter (minimum impedance : 20 KΩ per Volt in DC)
• Ammeter
3. an IMEI labels printing station, including :
• Printer,
• Roll of labels,
• Connecting cable for PC (parallel printer cable),
• Printing software,
To Next Page
Loading...
