Test Sheet 03 1/1
myC5-2
BATTERY TEST
Ref. SCT U38 SSC DTS 0024 – Index B - February 15, 2005 Page 4-43
Test description
This test allows to test the various batteries.
Required tools
− CADEX C7000 / C7200 / ASTRATEK
− Flex arm or myC5-2 adapters,
− a voltmeter (minimum impedance 20 kΩ per Volt in DC).
Test procedure
1. Measure the battery voltage between the V poles, the voltage shown must be between 2.5V and
4.5V.
If the voltage < 4v ,load the battery for 30 minutes with a universal charger and follow the instructions
below
If the voltage > 4V Measure the internal resistance with a CADEX or ASTRATEK batteries testers
Notice: Choose on the batteries tester ,the battery type (Li-ion) ,the nominal battery voltage (3,6V)
and the battery capacity (720 mA)
Read the result :If the internal resistance < 300 mOhms the battery is OK
If the internal resistance = 300 mOhms the battery is defective
To Next Page
Loading...
