Proc Sheet 1 05
myC5-2
REMOVING / REPLACING THE ELASTOMER
KEYPAD AND THE SIDE KEY
1/2
________________________________________________________________________________________________
Ref. SCT U38 SSC DTS 0024 – Index B - February 15, 2005 Page 5-20
4.36 Tools :
- Cross shaped screwdriver
4.37 Preliminary operation
1. Remove the battery pack ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 01).
4.38 Removal procedure :
1. Liberate the electronic board (1) by pushing the two stop pins (4) to outside, by means of tweezers
2. Lift equipped electronic board up (1) to liberate it of the front cover
3. Remove the keypad (2) and the side key (3) from the front cover.
4.39 Placement procedure:
1. Clean the keypad (2) and side key (3) with compressed air.
2. Place the keypad (2) and side key (3 ) in position in its housing
3. Place the equipped electronic (1) board in its housing
4.40 Further operations:
1. Replace the back cover ( Proc sheet 1 01).
2. Replace the battery pack ( Proc sheet 0 01).
To Next Page
Loading...
