Sagem myC5-2 - Page 92


Proc Sheet 1 13
myC5-2
REMOVING / REPLACING THE MICROPHONE
1/2
________________________________________________________________________________________________
Ref. SCT U38 SSC DTS 0024 – Index B - February 15, 2005 Page 5-37
4.77 Tools :
- Cross shaped screwdriver
- Soldering iron
- Solder wick
4.78 Preliminary operation
1. Remove the battery ( Proc sheet 0 01).
2. Remove the back cover ( Proc sheet 1 01).
3. Remove the equipped electronic board ( Proc sheet 1 09).
4.79 Removal procedure :
1. Unsolder the microphone (2) from the equipped electronic board (1)
2. Remove the microphone (2)
4.80 Placement procedure :
1. Flux the place of the microphone (2) and solder on the equipped electronic board (1), respecting the wiring sense
( Flex PCB upward )
4.81 Further operations :
1. Replace the equipped electronic board ( Proc sheet 1 09).
2. Replace the back cover ( Proc sheet 1 01).
3. Replace the battery pack ( Proc sheet 0 01).