WARNING: Position the unit at least 10 cm away from the rear wall. It is possible to place units side by side,
yet in any case there must be at least 5 cm space between one unit and another.
WARNING: Make sure that the unit is not exposed to direct sunlight, or any other sources of heat nor placed in
environments with high temperatures; any of these would cause the unit to wear more quickly and perform poorly.
The units have been declared to be in the 4 (T = 30° C U.R. = 55%) climate class.
Remove protective film from product.
This may cause unpleasant static electricity discharge which, however, is not dangerous.
The inconvenience is reduced or prevented by continuously holding the refrigerator with one hand or
grounding the package.
Gently remove the shelves paying great attention to not damage them.
Clean the unit and the shelves as described in the Chapter “CLEANING”. After having cleaned it, leave the
door open at least 72 hours before putting the unit into operation.
To install the shelves, follow what is indicated below:
• Beginning from the lowest shelf, grasp the shelf with both hands.
• Insert the steel hooks into the rack slots holding the shelf slight tilted upwards.
To Next Page
Loading...
Need help?
General
