IV.
Operating
inst
ructions
Energy Saving Tlp:
This machine with Soldering station, Hot Air Rework, De power supply
of
three
functions, when a function is not used, turn off the corresponding power switc
h,
when all function are not use, turn off the power switch (rear machine).
(A) Hot a
ir
rework operation
1. Desoldering station will be a good place, connected air gun handle, the h
an
dle
must be set in the handle racks,
ot
herwise a
ir
gun will not work (it has the uniq-
ue
security features, effective prevention
of
air
gun in unknown
circumstances
on
hold in other parts
of
fi
re
or
other accidents).
2. Connected power su
pp
l
y,
install the air nozzle
of
requi
re
d(to make use
of
large-
diameter noz
zl
e
).
3.
Open the
ai
r gun power switch, display window displays " _
__
" at this time desol-
dering station for stand
by.
4. Press butt
on
".
"or
Press b
utton"
...
" to set the temperature drop up or dr
op
down to the
de
si
red value then
re
lease it.
On
ce the temperature setup is comp-
lete, the Digital LED continues to dis
pl
ay t
he
set value 2s minutes
la
ter,
an
d
th
-
en
the display is maintained to real temperature valu
e,
the desoldering stati
on
will heating
no
rm
ally.
Ad
justed
ai
r volume knob to the
ri
ght w
in
d, when the tem-
pera
tur
e stable, it will be able to wo rk no
rm
ally.
5. Work is completed, must be put the
ha
ndle on the holder, at this time desolder-
in
g will automatic cut off the heati
ng
current into the b
od
y to send cold air cooli-
ng heating mode. When the temperature is belo
w.
100
0
(
shows "
___
" desolder-
ing station, that means the machine will enter into standby mod
e.
When the he-
a
ter
temperature below
70°(,
the machine
en
ter into standby (when there a
re
intermittent breeze, it means heater tempe
ra
ture higher than
70°C. On ly the temperature is actually lower than 70
°(,
the air supply will stop
work
in
g).
(8) Soldering Iron operatlon
1. The soldering iron handle connecte
d,
and put the handle on
th
e iran frame.
2. Open soldering iron pow
er
switch, Press b
utton"
• " or Press b
utton"
...
" to
set the temperature drop up or drop down to the desired value th en release it.
On.ce
the temperature setup is complete, the Digital LED continues to display
the set value 2s minutes later, and then the display is maintained to real tempe-
rature value, the desoldering station will heating normally. Adjusted air volume
knob to the right wind, when the temperature stabl
e,
it w
il
l be able to work nor-
mally.
(C)DC Power supply operation
1. Locate the adjustable voltage switch at the front's panel on the
bo
ttom right,turn
the knob to the desired value ( voltage
),
the can work normally. When using t
he
power supply load current exceeds rated current
(according
to models 1 A-3A )
ma
chine will be
au
tomatically protected, when the power load current
re
tu
rn
of
rated current for the machines automatically
in
1 OOus recove
ry.
10
To Next Page
Loading...