SainSmart Genmitsu 4040-PRO CNC Router

Need help?

Do you have a question about the SainSmart Genmitsu 4040-PRO CNC Router and is the answer not in the manual?

Summary

Welcome

Disclaimer

Specifications

Optional Accessories

Part 2- Mechanical Installation

Step 1: Preparing the machine for assembly

Instructions for preparing the front and rear modules and attaching rubber feet.

Step 2: Installing the MDF Spoilboard

Guide to attaching the MDF spoilboard using locating pins and bolts.

Step 3: Installing the Y-axis Module

Detailed steps for mounting the left and right Y-axis modules.

Step 4: Installing the X-axis Module

Instructions for installing the X-axis module onto the Y-axis modules.

Step 5: Installing the Z-axis Module

Procedure for installing the Z-axis module, including collet insertion.

Step 6: Installing the Z-axis Cable Mount

How to attach the Z-axis cable mount using screws.

Step 7: Secure the CNC Machine to your workbench or table. (Optional)

Optional steps to secure the machine to a workbench or table using two methods.

Step 8: Change the Spindle Holder (Optional)

Guide to changing the spindle holder for compatibility with different routers.

Tips

Part 3- Wiring

Cable Management

Instructions for managing cables using cable ties for organized wiring.

Part 4- Software Setup

1. Driver Installation

Steps to install the necessary USB driver for the machine's communication.

2. To Determine your Machines COM port

How to identify the correct COM port assigned to the machine in Device Manager.

3. Grblcontrol (Candle) Connecting to the Controller

Guide to connecting the Grblcontrol (Candle) software to the machine's controller.

Part 5- Test Project

1. Grblcontrol (Candle) Screen

Overview of the Grblcontrol (Candle) software interface and its key components.

2. Run G code for processing

Instructions on how to load and run G-code files for processing jobs.

3. About firmware parameters

Information about the pre-configured firmware parameters for the 4040-PRO.

Part 6- Z Probe Setup

Z Probe Function Introduction

Introduction to the Z-probe functionality and its operation.

Step 1: Editing the Probe commands

Procedure for editing probe commands in Grblcontrol (Candle).

Step 2: Probe commands filled in Grblcontrol (Candle)

How to input probe commands into the Grblcontrol (Candle) software.

Using the Z-Probe Function

Connecting the probe and using the 'Z-probe' button for automatic Z-axis zeroing.