SainSmart Genmitsu PROVerXL 4030

Need help?

Do you have a question about the SainSmart Genmitsu PROVerXL 4030 and is the answer not in the manual?

Summary

Welcome

Disclaimer

Specifications

Part 1 - Unboxing

Part 2 - Mechanical installation

Preparing Base Assembly

Details the steps and parts needed for preparing the base assembly of the CNC router.

Finishing Base Assembly

Guides on completing the base assembly, including spoilboard and dust baffle installation.

Preparing X-Axis Gantry

Instructions for preparing the X-Axis gantry, including motor and coupler installation.

Finishing X-Axis Gantry

Details on finishing the X-Axis gantry assembly, including drag chain mount.

Finishing Frame Assembly

Steps to complete the frame assembly by mounting the X-Axis gantry to the Y-Axis carriage mounts.

Installing X-Axis Drag Chain

Guide for installing the drag chain system for the X-Axis of the CNC router.

Installing Y-Axis Drag Chain

Instructions for installing the drag chain system for the Y-Axis of the CNC router.

Part 3 - Wiring

Wiring Electronics

Step-by-step guide for connecting the spindle, limit switches, and stepper motors to the electronics.

Label Description

Explains the meaning of various marks and labels used on the control board and components.

Final Checks

Final checks before powering on, including lubrication, cable connections, and emergency stop button.

Part 4 - Software Setup

Driver Installation

Guide on how to install the necessary USB driver for the CNC machine.

Determine Machine COM Port

Instructions on finding the correct COM port for your machine using Device Manager.

Connect Grblcontrol to Controller

Steps to connect the Grblcontrol software to the CNC controller via the COM port and set baud rate.

Part 5 - Test Project

Grblcontrol Interface Overview

Overview of the Grblcontrol interface for running test projects and manual operations.

Running G-code

Procedure for opening, sending, and executing G-code files within the Grblcontrol software.

Firmware Parameters

Information regarding firmware parameters configured for the PROVerXL 4030 control board.

Part 6 - Z Probe Setup

Probe Function Introduction

Introduction to the probe function and its operating instructions within Grblcontrol.

Probe Commands Editing

Details on editing probe commands for tool setting and tool lifting height configuration.

Probe Commands in Grblcontrol

Instructions on how to input and configure probe commands within the Grblcontrol software interface.

Connect and Zero Probe

Steps to connect the probe and use the Z-probe button in Grblcontrol to automatically zero the Z-axis.