Need help?Do you have a question about the Saitek CF5 Series and is the answer not in the manual?
General| Compatibility | PC |
|---|---|
| Manufacturer | Saitek |
| Device Type | Control Unit |
| Connectivity | USB |
| Type | Flight Controller |
| Series | CF5 |
Description of the status indicators on the burner control panel.
Crucial safety precautions for assembly, modification, and operation.
Declaration of conformity to European standards EN298 and Directive 90/396/EEC.
Details on where the CF5 flame control appliance can be applied.
Warning to avoid condensation inside the unit's enclosure.
Overview of power supply, working temperature, IP class, and detection thresholds.
Information on electrode/UV detection and ignition transformer compatibility.
Details on LED indicators and alarm contact behavior.
Description of the additional display card and its LED indicators.
Guidance on the correct mounting position and assembly of the device.
Guidelines for ionization and ignition cable length and type.
Instructions for wiring, including phase usage, voltage, current, and grounding.
Visual representations of internal connections and external wiring.
Step-by-step guide for putting the burner control unit into service.
Specific guidance regarding the terminal box and its remote unlocking functionality.
Procedure to check if the burner control unit is functioning correctly.
Visual representation of the operating sequence when starting without an existing flame.
Visual representation of the operating sequence when starting with an existing flame.
Visual representation of the unit's behavior during a restart after a flame failure.
Configuration options for re-igniting after flame loss and number of attempts.
Configuration for the daily self-check of the flame detection circuit.
Options for setting the pre-purge duration before ignition.
Configuration for ignition duration and safety time for flame loss.
Visual representation of the operating status when self-check is successful.
Visual representation of the status when no flame is detected during self-check.
Warning regarding electrical shock hazard and personnel qualifications.
Diagnosing and resolving problems related to the ignition spark.
Diagnosing and resolving issues with gas supply to the burner.
Resolving issues when the unit fails to start or perform the ignition cycle.
Diagnosing and resolving problems with flame detection.
Details on the warranty period for defects in material and workmanship.
To Next Page