SAJ PDS33 Series

To Next Page

To Previous Page

PDS33 Series

- 3 -

2.5.1 Outline &installation dimensions diagram........................................... - 16 -

Chapter 3 Mechanical and Electrical Installation.........................................- 19 -

3.1 Mechanical Installation..............................................................................- 19 -

3.1.1Overheat protection..................................................................................- 19 -

3.1.2 Location Selection....................................................................................- 19 -

3.2 Electrical Installation................................................................................. - 21 -

3.2.1 Terminals.................................................................................................. - 21 -

3.2.2 Power in DC Wiring................................................................................ - 22 -

3.2.3 Junction box connection..........................................................................- 22 -

3.2.4 Ground Wiring.........................................................................................- 23 -

3.2.5 Motor Wiring........................................................................................... - 23 -

3.2.6 Low water level probe wiring (optional)............................................... - 23 -

3.2.7 Water tank level float wiring (optional).................................................- 24 -

3.2.8 Electrical conduit.....................................................................................- 25 -

3.2.9 System Wiring Diagram..........................................................................- 25 -

Chapter 4 Start-up and Operation..................................................................- 26 -

4.1 Keypad Description.................................................................................... - 26 -

4.2 Keypad Operation Process........................................................................ - 27 -

4.2.1 Parameter Setting.................................................................................... - 27 -

4.2.2 Fault Reset................................................................................................- 28 -

SAJ PDS33 Series - Page 4