Salamander SYNERGY 323 User Manual

BEFORE YOU BEGIN:
• Unpack all parts before beginning and refer to the drawing below.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
They cannot be removed individually without disassembling the whole unit.
SYNERGY 323
Twin Instructions
Includes:
(1) Twin 20 Unit
(2) S30 Side Panels
(2) S30 Doors
!
!
Limited Warranty
For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment conse-
quential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging
shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only. Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com
©2002 Salamander Designs Ltd.
Top Shelf (1)
Adjustable Shelf (4)
Bottom Shelf (1)
Joint Connector Bolt 300-540 (6)
Foot & Nut P-300-350 (6)
Door (2)
Aluminum Post (6)
Sides (2)
Washer 300-470 (6)
Shelf Peg
PHK-370 Right (8)
PHK-380 Left (8)
Doc No. 500-750/v2.12 323 -1/4

Salamander SYNERGY 323 Specifications

General

Brand	Salamander
Model	SYNERGY 323
Category	Indoor Furnishing
Language	English

Summary

Before You Begin

Product Components

Connect Posts to Bottom Shelf

Square Post

Describes how to square the post to the bottom shelf, ensuring a 90-degree angle.

Connect Post

Details attaching the post to the bottom shelf using a leveler foot, washer, and hex nut.

Add Shelf Pegs & Door Hinges

Group Shelf Pegs

Explains the two varieties of shelf pegs (A and B) designed to cradle shelves.

Insert Hinges & Add Shelf Pegs

Guides inserting hinge plates and shelf pegs into post channels for door attachment.

Attach Door

Attach Hinges to Door Frames

Instructs on inserting and locking hinges into the corresponding holes on the doors.

Adjust Clearance

Details adjusting door height to 1/8" above the bottom shelf using wrench thickness.

Rubber Stops

Guides placement of rubber stops inside the door frame to prevent impact.

Door Pull

Instructs on screwing the door pull into its designated place.

Attach Rear Panel

Insert Hardware

Combines threaded studs with flat nuts, sliding hardware into the rear channel.

Place Panel

Aligns the rear panel studs through post holes for cable passage spacing.

Secure Studs

Utilizes a hex key to securely fasten all studs to the posts.

Final Assembly

Placing & Adjusting Shelves

Guides placing shelves from bottom up, angling them onto shelf pegs.

Fine Tuning

Ensures precise shelf leveling using a bubble level and tightening pegs.

Insert Side Panels

Details sliding side panels into the center channel of the outside post.

Secure Rear & Top

Completes panel installation by attaching remaining thumb nuts to the rear and top.

Limited Warranty