Why my Salem Master Pro Chainsaw won't start?
If your Salem Master Pro Chainsaw won't start or starts but doesn't continue to run, it could be due to several reasons. First, ensure you are following the correct starting and stopping instructions. A fouled spark plug can also cause this issue, so clean, gap, or replace it. Lastly, check if the fuel tank is empty and, if so, fill it with properly mixed fuel.
What to do if my Salem Master Pro 6220G Chainsaw starts but has low power?
If your Salem Master Pro Chainsaw starts, but the engine has low power, several factors could be responsible. Check the choke position and move it to fully close. A dirty spark arrestor screen or air filter can also cause low power, so clean them. If these steps don't resolve the issue, the carburetor mixture adjustment setting might be incorrect.
Why does my Salem Master Pro Chainsaw engine hesitate?
Engine hesitation in your Salem Master Pro Chainsaw can stem from a few causes. A plugged air filter could be the culprit; try cleaning or replacing it. Also, old or improperly mixed fuel can lead to hesitation, so drain the fuel tank and add fresh, properly mixed fuel. The carburetor mixture adjustment setting might also be incorrect.
General| Power Source | Gasoline |
|---|---|
| Engine Displacement | 62cc |
| Bar Length | 20 inches |
| Engine Power | 3.5 HP |
| Fuel Tank Capacity | 550 ml |
| Oil Tank Capacity | 260 ml |
| Chain Gauge | 0.058 inch |
| Weight | 6.5 kg |
| Chain Pitch | 0.325 inches |
To Next Page
