What to do if the water shortage indicator light is on in my salling 10100956?
If the water shortage indicator light is illuminated, it could be due to two reasons: either there is no water in the unit, or the pump is full of air. First, add water until it reaches the MAX position. If that doesn't resolve the issue, press the POWER button to restart the ice maker.
What to do if my Salling Ice Maker is stuck and not working?
Your Salling Ice Maker might be stuck because the water box is blocked by ice, the motor is stuck, has fallen off, or is damaged, or the micro switch is damaged. You can try to remove the ice under the ice shovel, plug in the power again, and press the Power button. After 3 minutes, the machine will restart automatically. If that doesn't work, contact the place of purchase.
What to do if the indicator lights on display are not on in my salling 10100956?
If the indicator lights on the display are not illuminated, it indicates a blown fuse or a lack of power. You should replace the fuse or turn the power on.
What to do if the ice made by my salling 10100956 is too large and with pieces sticking together?
If your ice maker produces ice that is too large and the pieces are sticking together, it could be caused by wrong ice size selected or ice of previous cycles left in the water tray. Try selecting the small size. Also, take out the ice under the standby state.
Why does my salling 10100956 Ice Maker compressor work abnormally with a buzzing noise?
If the compressor is making a buzzing noise, it's likely due to the voltage being lower than recommended. Stop the ice maker and do not restart it until the voltage is normal.
What to do if small ice chips form and jam the automatic shovel in my salling 10100956?
If small ice chips are causing the automatic shovel to jam, disconnect the power cord and gently push the shovel to the rear of the cabinet, remove the ice chips, and then restart the machine.
What to do if my salling 10100956 made ice, but no ice came out?
If the ice making process was correct, but no ice came out, it could be due to the compressor having no refrigerant, a damaged compressor, or a damaged fan motor. Contact the place of purchase.
What to do if my salling 10100956 Ice Maker has been working, but the water has been warming?
If the water in your ice maker is warming up, it is likely that the solenoid broke down. Replace the solenoid valve.
What to do if my salling 10100956 does not display the ice full icon when the ice is full?
If the ice full icon isn't appearing when the ice is full, the ice full sensor may be damaged. You can try to replace the ice full sensor or contact the place of purchase.
To Next Page
General