Salter Labs 7100 - User Manual

Home
Use
Bubble Humidifier Instructions for Use
and Cleaning Instructions
Instructions for Use
1. Wash hands and remove bubble humidier from package.
2. Unscrew lid and add water to the Maximum Level marking
on the side of the bottle. Sterile, distilled or boiled water is
recommended.
3. Replace lid and ensure lid is screwed on tight.
4. Attach bubble humidier to oxygen source, i.e. owmeter,
concentrator, liquid tank.
5. Test for leaks (A). Turn the ow to 6 LPM and block the
outlet port on the bubble humidier. An alarm should sound in
5 seconds or less. If not, check connections.
6. Attach oxygen tubing to the outlet port (B) and adjust ow to
prescribed setting.
7. Apply interface, i.e. nasal cannula or oxygen mask, to patient.
8. If water level drops to Minimum level marking on bottle, add
more water.
The Bubble Humidifier is a disposable, single-patient
use device for use in health care facilities and home care.
The humidifier is used to provide additional humidity to
supplemental oxygen therapy and is available with either a
3 PSI or 6 PSI safety pop-off valve.
7100 Bubble Humidifier- 3 PSI Pop-off | 7600 Bubble Humidifier- 6 PSI Pop-off
MAXIMUM
Pressure
relief alarm
Pressure
relief port
Maximum
water level
Minimum
water level
Diffuser
Oxygen
outlet port
MINIMUM
Oxygen source
O
2
Source
MAXIMUM
MINIMUM
(A)
MAXIMUM
MINIMUM
Oxygen
Tubing
To
Patient
O
2
Source
(B)

Summary

Instructions for Use

Adding and Preparing Water

Prepare humidifier, add sterile distilled water to maximum level, and ensure lid is secure.

Connecting to Oxygen Source

Attach the bubble humidifier to the oxygen source, like a flowmeter or concentrator.

Leak Testing

Test for leaks by blocking outlet port at 6 LPM; an alarm should sound within 5 seconds.

Connecting Oxygen Tubing and Use

Attach oxygen tubing, adjust flow, apply interface, and refill water as needed.

Cleaning Instructions

Washing Procedure

Wash the bubble humidifier with warm soapy water every 14 days.

Rinsing and Replacement

Rinse thoroughly with distilled or boiled water and replace the humidifier every 30 days.

Tap Water Usage Note

If using tap water, wash the humidifier every 3 days.

Final Setup

Salter Labs 7100 Specifications

General

Brand	Salter Labs
Model	7100
Category	Humidifier
Language	English