Salton Elite SIM30E - User Manual

Questions and Answers

D
Drew SmithAug 1, 2025
Why is the 'FILL WATER' indicator on my Salton Elite SIM30E when the tank is full?
- W
  williamhooperAug 1, 2025
  If the 'FILL WATER' indicator is on even though there's enough water in the tank of your Salton Ice Maker, it could be due to these reasons: * The water pump might be damaged and unable to pump water. In this case, contact your local service department. * The water detector might not be 'seeing' the water. To fix this, adjust the water detector to aim it at the outlet of the water pipe.
B
Bill ContrerasAug 7, 2025
Why does my Salton Elite SIM30E stop suddenly while making ice?
- D
  Daniel McguireAug 7, 2025
  If your Salton Ice Maker stops suddenly during the ice-making process, it's possible that the surge protector stopped the machine because it was too hot. Turn off the machine and restart it after one hour.
R
rcampbellAug 12, 2025
What to do if 'fill water' and 'ice full' indicators are on at the same time on my Salton Elite SIM30E?
- W
  William BlairAug 12, 2025
  If both the 'fill water' and 'ice full' indicators are lit on your Salton Ice Maker, it could be due to several reasons: * The ice shovel may be unable to work. To resolve this, remove the ice and restart the machine. * The ice storage box might be full, causing the shovel to be blocked by ice. Remove the ice and restart the machine. * The ice produced may be too large, obstructing the shovel. In this case, turn off the machine, remove the ice, and then restart it. * The shovel might have shifted out of place and is blocked. Turn off the machine and reposition the shovel. * The position switch might be unworkable. In this case, contact your local service department.
M
Matthew MurrayAug 18, 2025
What to do if the 'ICE FULL' indicator is on but the Salton Elite SIM30E storage box is empty?
- S
  Sherri HarperAug 18, 2025
  If the “ICE FULL” indicator is on but there is little ice in the storage box of your Salton Ice Maker, it may be caused by the temperature of the storage box being too low. To resolve this, open the front cover and close it until the indicator light turns off.
T
Tracey OdonnellAug 25, 2025
How to fix a Salton Elite SIM30E compressor that makes a thundering noise?
- H
  Heather GarciaAug 25, 2025
  If the compressor of your Salton Ice Maker is making a thundering noise, it is likely that the voltage is lower than required. Turn off the machine and restart it once the voltage becomes normal.