Need help?Do you have a question about the Salton IM2096 and is the answer not in the manual?
Do not immerse cord, plugs, or appliance in water or other liquid. Ensure proper grounding.
Avoid letting the cord hang or touch hot surfaces. Do not place near heat sources.
Use only for intended use, do not leave unattended, and follow plug/unplug procedures.
Overview of buttons and indicator lights for operation and status.
Details on the ice basket, water reservoir, and evaporator fingers.
Information on the drain plug and water tube screen for maintenance.
Instructions for unpacking, positioning, and ensuring proper ventilation.
Wait one hour before operating to allow refrigerant fluid to settle.
Wash interior and make two batches of ice to discard.
Fill reservoir, plug in, select ice size, and start the cycle.
Action when 'Ice Full' light appears and how to restart the cycle.
Action when 'Add Water' light appears and how to refill.
Transfer ice to freezer and shut down the unit.
Replace water in the reservoir every 24 hours for cleanliness.
Wait 3 minutes before restarting the compressor after a stop.
Cloudy ice is normal; recommended room temp is 50-100°F.
Stop cycle, unplug, allow to warm up, and drain water.
Clean interior with vinegar solution, exterior with damp cloth.
Important note: Do not clean the Evaporator Fingers.
Troubleshoot 'Add Water' light by checking water level or filter.
Address 'Ice' light by removing ice from the basket.
Check power, fuse, or circuit breaker if indicator lights are off.
Diagnose no ice production or jammed ice shovel.
Resolve issues with water not filling the tray by cleaning the screen.
To Next Page
General
