authorized service representative. See Warranty section.
IMPORTANT NOTES:
• Never use abrasive cleansers to clean any part of the Pressure Cooker
• Store the Pressure Cooker with the Cover resting upside down on
the Removable Cooking Bowl. Never seal the Cover on the Pressure
Cooker when storing.
Cleaning the Pressure Regulator and Exhaust Pipe
Check that the Pressure Regulator Knob, Blockage Guard and Exhaust
Pipe are in good working order before each use.
1. When the Pressure Cooker Cover is cool, lift the Pressure
Regulator Knob and remove.
2. Turn the Cover over and gently remove the Blockage Guard.
Wash and dry.
3. Hold the Pressure Cooker up to the light to be sure that there
are no obstructions in the Exhaust Pipe. Clean with a pin or
metal wire, if necessary. NEVER USE THE PRESSURE
COOKER IF THE EXHAUST PIPE IS BLOCKED.
4. Reinstall the Blockage Guard over the Exhaust Pipe.
5. Reinstall the Pressure Regulator Knob by gently pushing it back
into position.
TROUBLE SHOOTING
1) If you have not added sufcient liquid and you notice that the
Pressure Indicator Valve has not risen but the timer is counting
down, follow the steps below:
• Stop the Pressure Cooker by pressing the Keep Warm/
Cancel button.
• Turn the Pressure Regulator to Exhaust position until the
pressure is fully released.
• Remove the Cover and add a minimum of 1 cup (250 ml)
of liquid. Stir food to disperse liquid.
• Replace the Cover and lock into position.
• Reset the program.
2) If steam is leaking from under the Cover because the Cover
is not properly closed, the Gasket may not be positioned properly
or is damaged or the Pressure Cooker is overlled. Follow the
steps below:
18
To Next Page
Loading...
