CAUTION: PRESSURE
CAUTION: The unit is under pressure when in use. DO NOT remove the boiler cap
until pressure is completely relieved.
TO ENSURE ALL PRESSURE IN THE UNIT IS RELIEVED:
1. Turn the selector knob on the side to “Off” and unplug the unit from the power
source.
2. Remove the filter holder and dispose of coffee grounds.
3. Re-install the filter holder and the empty carafe.
4. Turn the steam selector control knob to the “cup” position and allow all pressure and
residual water to completely drain off the carafe. Once all flow and sound ceases the
pressure is removed.
OPERATING INSTRUCTIONS
BEFORE USING YOUR CAPPUCCINO MAKER FOR THE FIRST TIME:
Wash the carafe, reservoir plate, stainless steel cup and filter holder in warm water
with a mild detergent. Rinse the cup and filter well. Wipe down the frothing tube with
clean warm water.
Rinse the inside of the machine by following the instructions for brewing espresso,
using water only and no ground coffee .
TO BREW ESPRESSO:
Unwind the desired length of electrical cord from the base of the unit. Place the
reservoir plate on the base.
Ensure the selector knob is on the “Off” position. Remove the water tank boiler cap.
Carefully measure out 120ml of water for 2 servings. You can also use the glass
carafe to measure the water. Pour the water into the water tank. Do not fill the water
tank to full, as the unit will not be able to create steam.
Replace the water tank boiler cap. Ensure that it is on tight.
Grip the filter handle and slide it to the left until it is in line with the arrow. The filter
holder will now release. Place the steel cup in the filter holder.
To Next Page
Loading...
