Mounting the RF Integral Boiler Control to the boiler
DANGER!
• 24V & 230V: Do not Touch Electrical Components or circuits
• Isolate mains electricity supply before starting any work
and observe all relevant safety precautions
• Follow electro static discharge precaution.
Do not touch any visible PCB parts or components.
1. Switch off the boiler at its main supply. Remove the outer casing and front
fascia to allow access to the main control panel.
2. Remove cover panel A upwards to remove.
3. Pull top tab B upwards, then outwards to remove blanking plate or existing control.
Now you are ready to fit your Salus integral RF boiler control
9ST620WBC INSTRUCTION MANUAL
B
A
To Next Page
Loading...
