Distance flaps to pin is 3mm
Distance aileron to pin is 0,5mm
Glue the aileron and flap horns. When using the IDS from servorahmen.de the
horns will be glued flush with the upper surface for both aileron and flaps. Mount
the pushrod to the horn to ensure easy positioning while glue is settling.
When not ordering the IDS there is fiberglass horns provided in the set.
Glue the servos/IDS frame in using epoxy. If the epoxy is thin it is possible to add
some thixotropy agent. It is also possible to use Cyano glue in small amounts
Install the threads and clevises whilst the servo arms are set 90 degrees on the
servos and the ailerons / flaps are set in neutral position. When using
thread/clevis secure the thread to the clevis with extra thin CA as this is a place
with some slop. Check also thoroughly the clevis pins going into the horns and
servo arms. There are clevises that can be poorly made in this special detail. Use
the inner most hole on the servoarms possible to ensure full power of the servo
yet providing full throw.
On ailerons it is possible to use a simple bent 1,5mm pushrod with the
servorahmen setup.
To Next Page
Loading...
