21
Danger by operation fault and lowering judgement.
Danger by dropping.
Never attempt to operate a machine while
under the inuence of alcohol or drugs.
When lifting chuck, use eyebolt or wire rope.
Danger by discharge of workpiece, if it is too long.
When machining a long workpiece, support
it with a center, tailstock or steady rest.
Danger by discharge of chuck or workpiece in case of
damaging of chuck.
Do not attempt to modity chuck.
Danger by catching in a machine.
Gloves and ties should not be worn when
operating a machine.
Workpiece Tailstock
Center
NO!
NO!
Alcohol, Drugs
NO!
If chips accumulate and interfere with operation, it can
be danger by discharge of chuck or workpiece due to
reduced gripping power. If a lot of chips accumulate,
machine the lower part of the top jaw to allow the
chips to drain smoothly.
After machining, remove the chips accumu-
lated between the top jaw and the chuck
body with an air gun, etc.
MACHINING
AIR
Chip
Eyebolt
Lathe
Wire rope
To Next Page
Loading...
