SAMCOM T2 - CDCSS Code Chart; Safety and General Information; Compliance with RF Exposure Standards

6
82.5
13
103.5
20
131.8
27
167.9
34
218.1
7
85.4
14
107.2
21
136.5
28
173.8
35
225.7
CDCSS Octal Code Chart
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
Code
No.
OCT
Code
39
023
52
074
65
165
78
271
91
413
104
565
117
731
40
025
53
114
66
172
79
306
92
423
105
606
118
732
41
026
54
115
67
174
80
311
93
431
106
612
119
734
42
031
55
116
68
205
81
315
94
432
107
624
120
743
43
032
56
125
69
223
82
331
95
445
108
627
121
754
44
043
57
131
70
226
83
343
96
464
109
631
45
047
58
132
71
243
84
346
97
465
110
632
46
051
59
134
72
244
85
351
98
466
111
654
47
054
60
143
73
245
86
364
99
503
112
662
48
065
61
152
74
251
87
365
100
506
113
664
49
071
62
155
75
261
88
371
101
516
114
703
50
072
63
156
76
263
89
411
102
532
115
712
51
073
64
162
77
265
90
412
103
546
116
723
SAFETY AND GENERAL INFORMATION
Compliance with RF Exposure Standards
Your GMRS Two-way radio generates RF electromagnetic energy during transmit mode. This two-way radio
is designed, manufactured and tested to comply with all applicable national and international regulations
for human exposure to radio frequency electromagnetic energy.
Class B Digital Device
This radio has been tested and found to comply with the limits for a Class B digital device which pursuant to the part 15
of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.